Rcbs Pro 2000 Auto Index Reloading Press User Manual

Pro 2000® Auto Index PROGRESSIVE RELOADING PRESS PRODUCT INSTRUCTIONS

- 10 -POWDER MEASURE INSTALLATION Slip the slotted portion of cylinder link over the drive pin. See photo E. Photo E Now install the cylinder link

- 11 -PRESS OPERATION We recommend that several cases be completely reloaded one at a time before proceeding with full operation. This will help you

- 12 -PRO 2000 AUTO INDEX OPERATING PROCEDURE Now that you have read the instructions and are familiar with your Pro 2000 Auto Index, you are ready t

- 13 - Key # Part # QTY Description 1 102505 1 PRO 2000 PRIMING PLATE 2 109509 1 8-32 x 1/4 SET SCREW 3 109604 1 1/4-28 HEX NUT 4 109700 1

- 14 - 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 33 34 35 36 37 32 7

- 15 -PRO 2000 AUTO INDEX PRESS Key # Part # Qty Description 1 109121 1 RC PRESS HANDLE BALL 2 109136 1 HEX JAM NUT 5/8”

- 16 - KEY # PART # DESCRIPTION KEY # PART # DESCRIPTION 1 7709025 UPM MAIN CASTING 18 71872

- 17 - Accessories for your Pro2000 (not included) 9634 Die Lock Ring Wrench 88877 Die Plate 82

- 18 - PRECISIONEERED RELOADING EQUIPMENT We think that we make the very best reloading equipment in the world. If you agree, please tell your fr

- 2 - WARNING Before using the RCBS Pro 2000 Auto Index Progressive Press, read these instructions carefully to fully learn how to safely operate t

- 3 -PRIMERS AND POWDER • Store primers and powder beyond the reach of children and away from heat, dampness, open flames and electrical equipment.

- 4 - PRESS ASSEMBLY 1. Select a solid bench on which to mount the Pro 2000 Auto Index Press. You must use the two slots for mou

- 5 -3. Install the Pro 2000 handle and tighten the handle and nut. See photo 2. Photo 2 4. Install the Bullet Tray with two 8-32xl/4" socke

- 6 -13. Thread in the Case Activated Powder Measure assembly into Station 3 of the Press Frame. 14. Install Die Plate and lock into place with the

- 7 -BULLET SEATING WITHOUT CRIMPING CAUTION: Do not adjust the Seater Die down against the shell plate as it will distort or crush the case. These

- 8 -Lower and then raise the handle to run the cartridge back into the Seater Die. Check the crimp. If more crimp is desired, repeat the preceding s

- 9 - CAUTION: DO NOT leave powder in the measure, as it will deteriorate and may clog and jam the measuring cylinder and etch the powder hopper. In